Skip to content

🖨️ 3D-Printable Cases & Accessories

These are the most useful community-made cases and holders for InkyCal builds. They are especially handy if you want a cleaner frame, a battery-powered setup, or a more compact desktop build.

  • :material-printer-3d: Inkycal PiSugar Frame

    Official MakerWorld design by aceisace.

    A custom frame for Pi Zero + PiSugar + e-paper display.

    Inkycal PiSugar frame

    Open design

  • :material-home-variant: IKEA Frame Mounting Parts

    Community design by Ribitsch.

    A simple mounting set for turning a standard frame into an InkyCal display.

    IKEA frame mounting parts

    Open design

  • :material-monitor: Waveshare E-Paper Display HAT Holder

    Community design by eboda.

    A minimal sleeve and stand for desktop display use.

    Waveshare display holder

    Open design

Printing notes

  • PLA is fine for indoor use; PETG is better if the frame sits in a warm place.
  • A 0.2 mm layer height is a good default.
  • Use 15–20% infill unless the design asks for more.
  • Check supports before printing large front covers or clips.